Paper 6 - post your doubts are

[Brain Box]

if you need help with paper 6 just post your doubts are and i will help you

 

[Abby ay]

Umm can u help me out with this question
M/J-05
Q-5
if u can could u post the pic aswell

 

[shiznini]

How can we check if a meter rule is vertical and/or horizontal?

 

[Abby ay]

By using a set square or a protractor

 

[eshal khan]

By using a set square or a protractor

lol then dunt forget to teach me tom how to use a protacter and a set square

 

[Z.A.M]

Can any1 answer my question
How to draw a ruler clamped to a bench
Diagram if possible....

 

[Abby ay]

lol then dunt forget to teach me tom how to use a protacter and a set square

sure

 

[Z.A.M]

Can any1 answer my question
How to draw a ruler clamped to a bench
Diagram if possible....

My question ny1????

 

[Abu mota]

oct/november 2005 question 2, i cant draw a circuit and i usually get this question wrong all of the time so teach me the principle too plz and ty

 

[Abu mota]

i dont understand how do u draw the resistors, if they are lines, i dont know how to convert the wires to resistors.

 

[ATTAR96]

how to find gradient using triangular method? plzz

 

[thats_me]

oct/november 2005 question 2, i cant draw a circuit and i usually get this question wrong all of the time so teach me the principle too plz and ty

question : u need to draw the same as (ii) using standard symbols , u need to connect using lead (connecting wire) A &D in (ii) CD is already connected to C (AB & BC are in series) so to connect it to A u need to draw it parallel with the other 2

 

[angelicsoul]

HELP PLEASE!! may/june 2008 qs 1(b) physics p6
The cylinder completely covers the marks on the metre rule. Describe, with the aid of
a diagram, how you would judge that the centre of the cylinder is directly above the
10.0 cm mark

 

[Abu mota]

Just draw a box to represent the cylinder and then measure the ends of the cylinder and then add those measurements and divide by two. I hope I helped

 

[angelicsoul]

Just draw a box to represent the cylinder and then measure the ends of the cylinder and then add those measurements and divide by two. I hope I helped

thnks a lot! also ... whenever they ask ways to minimise temperature rise/heating effect in wires what are the best options ?

 

[Nimaay]

Low curent

 

[angelicsoul]

Low curent